中国电机工程学报 2006, 26(3) 136-140  DOI:      ISSN: 0258-8013 CN: 11-2107/TM

本期目录 | 下期目录 | 过刊浏览 | 高级检索                                                            [打印本页]   [关闭]
电工电机
扩展功能
本文信息
Supporting info
PDF(244KB)
[HTML全文]
参考文献[PDF]
参考文献
服务与反馈
把本文推荐给朋友
加入我的书架
加入引用管理器
引用本文
Email Alert
文章反馈
浏览反馈信息
本文关键词相关文章
无轴承电机
永磁同步电机
径向悬浮力
有限元
优化
本文作者相关文章
朱熀秋
张涛
PubMed
Article by
Article by
无轴承永磁同步电机有限元分析
朱熀秋 张涛
江苏大学电气信息工程学院 江苏大学电气信息工程学院
摘要: 无轴承永磁电机径向悬浮力与电机绕组结构、永磁体厚度及悬浮力绕组中电流等存在着复杂关系,研究这些关系对电机优化设计具有重要参考价值。该文在介绍了无轴承永磁同步电机径向悬浮力产生原理基础上,推导了径向悬浮力数学模型。用有限元分析和计算方法,讨论了无轴承永磁同步电机在定子绕组相应等效电流作用下,改变径向悬浮力绕组中的电流,电机气隙磁路分布状况;在电机气隙不变,改变永磁体厚度,计算和分析了径向悬浮力与永磁体厚度之间的关系;在电机转矩绕组极对数pM=2不变的情况下,对径向悬浮力绕组采用一对极pB=1和三对极pB=2方式绕制,计算和比较产生的径向悬浮力和麦克斯韦力大小。对pM=2,pB=3的实验样机,在静态悬浮状态下,测试了径向悬浮力和径向悬浮力绕组电流之间的关系,实验结论验证了ANSYS软件计算结果的正确性。
关键词 无轴承电机   永磁同步电机   径向悬浮力   有限元   优化  
Finite Element Analysis for Bearingless Permanent Magnet-type Synchronous Motors
ZHU Huang-qiu ZHANG Tao
Abstract: There are complicated relationships among the radial suspension forces, configuration of windings and currents for a bearingless permanent magnet-type synchronous motors(BPMSM), so researching these relationships has important reference value for designing and optimizing BPMSM. Based on the principle of producing radial suspension forces on BPMSM, the mathematics models of radial forces on BPMSM is deduced. The gap magnetic circuits of BPMSM are studied using finite element method when the currents in radial force windings are changed under the invariable equivalent current in torque windings. The relationship between the radial suspension forces and permanent magnet thickness is calculated and analyzed when the permanent magnet thickness is changed under the fixed motor gap. The radial suspension forces and the Maxwell forces of the additional 2-pole radial windings and additional 6-pole radial windings are compared under the 4-pole motor windings. The relationship between radial suspension forces and current is tested on prototype machine with pM=2 and pB=3 under the state of static suspension; the experiment conclusions have proved that the account results are accurate by using ANSYS software.
Keywords: Bearingless motor   Permanent magnet-type synchronous motor   Radial suspension force   Finite element   Optimization  
收稿日期 2005-03-30 修回日期 1900-01-01 网络版发布日期  
DOI:
基金项目:

通讯作者: 朱熀秋
作者简介:
作者Email: zhuhuangqiu@ujs.edu.cn

参考文献:
本刊中的类似文章
1.年珩 贺益康 黄雷.内插式永磁无轴承电机转子位置/位移综合自检测[J]. 中国电机工程学报, 2007,27(9): 52-58
2.张涛 朱熀秋.无轴承永磁同步电机转子质量不平衡补偿控制[J]. 中国电机工程学报, 2007,27(15): 33-37
3.周媛 贺益康 年珩.永磁型无轴承电机的完整系统建模[J]. 中国电机工程学报, 2006,26(4): 134-139
4.徐龙祥 朱小春 姚凯.片状无轴承磁电机的研究[J]. 中国电机工程学报, 2006,26(6): 141-145
5.成秋良 朱熀秋.无轴承永磁同步电机增磁调压转速控制策略[J]. 中国电机工程学报, 2009,29(3): 91-95
6.仇志坚 邓智泉 王晓琳 孟令孔.新型交替极无轴承永磁电机的原理与实现[J]. 中国电机工程学报, 2007,27(33): 1-5
7.仇志坚 邓智泉 王晓琳.无轴承永磁同步电动机的独立控制研究[J]. 中国电机工程学报, 2006,26(1): 115-119
8.朱熀秋 成秋良.无起动绕组永磁同步电机初始定位及起动策略[J]. 中国电机工程学报, 2008,28(9): 61-65
9.卜文绍 万山明 黄声华 刘文胜.无轴承电机的通用可控磁悬浮力解析模型[J]. 中国电机工程学报, 2009,29(30): 84-89

Copyright by 中国电机工程学报